Recommendation: Perform this step while sitting at a table. 1. Insert EZ View plastic numbered film (0-9) into the slot on the bottom of the white surface.	US.Patent No. 6,304,818 Worldwide Patent Pending
2. (a) Remove activation plug from under EZ View sticker. (b) Pull out the plug, this piece is the activation plug.       EZ View US.Patent No. 6,304,818 Worldwide Patent Pending EZ View US.Patent No. 6,304,818 Worldwide Patent Pending
3. Place activation plug into the female portion of EZ View unit.	EZ View US.Patent No. 6,304,818 Worldwide Patent Pending
EZ View has a solar powered panel located on the bottom half of the unit. This panel must be directly exposed to the sky - do not place under an awning as the EZ View solar panel needs an unobstructed view of the sky to recharge the batteries. 2. Direct exposure to the sun, is not required. 3. WARNING: Do not place the EZ View unit next to a lamp, as the unit must detect darkness in order to automatically illuminate.	EZ View US.Patent No. 6,304,818 Worldwide Patent Pending
For drilling into most surfaces: 1. Connect each EZ View unit (on the side) to its Adjacent unit. 2. An attached horizontal series of EZ View numbers requires a total of 2 screws(one screw at each outer most end.)	EZ View US.Patent No. 6,304,818 Worldwide Patent Pending
For drilling into very hard surfaces ( concrete ) 1. Drill 2 holes using a 7/32” drill bit. 2. Insert masonry bit 3. Inscrt 2 screws (included) and tighten. 4. Cover screw-holes with enclosed EZ View caps.	EZ View US.Patent No. 6,304,818 Worldwide Patent Pending